Dodge · 1971–2001
25 known recalls affecting the Dodge Ram Van (1971–2001). Enter your VIN to check if your specific vehicle is affected, or browse by model year below.
On certain vehicles, the ignition/park shift interlock system may become inoperable. This can allow the shifter to be moved out of the PARK position with the ignition key removed (or in the lock position) or it could allow the ignition key to be removed when the shifter has not been placed in the PARK position. This could allow the vehicle to roll away, possibly causing property damage and/or personal injury or death. Correction: Dealers will replace the gearshift blocker and bracket assembly.
On certain vehicles, aftermarket batteries may leak electrolyte onto the ABS control module connector and compromise the sealing integrity of the connector. This may allow development of a high resistance short circuit in the connector, which could eventually lead to a fire. Correction: Dealer will inspect the ABS control module connector for electrolyte damage, and replace the connector as necessary. All affected vehicles will also have a shield installed to protect the connector from future battery electrolyte leakage.
Certain Ram trucks equipped with a diesel engine. The potential is for the throttle control linkage joints to corrode and cause the throttle to bind or stick, which could result in a loss of throttle control. Correction: Dealers will replace the rod ends and ball studs.
Certain vans and wagons. In the presence of road salt, water, and possibly other debris, the power seat connector located beneath the driver's seat could develop a high resistive short circuit that cycles the circuit breaker. If the circuit breaker cycles for an extended period of time, a sufficient amount of heat could build up in the connector, possibly resulting in a fire. Correction: Owners will receive instructions for removing the circuit breaker from the fuse panel. If an owner desires, their dealer can perform the repair.
Certain vehicles fail to comply with requirements of C.M.V.S.S. No. 209, "Seat Belt Assemblies." The front seat belt retractor may not work properly, it therefore will not adequately protect occupants in the event of a crash. Correction: Dealers will replace the seat belt retractor.
On certain vehicles, the air bag electronic control module (AECM) will corrode if water/road salt is introduced onto the interior floor in the proximity of the AECM. The resulting corrosion of the AECM could cause the driver's side air bag to deploy inadvertently. Correction: Dealers will replace the existing AECM with one that is sealed from moisture intrusion.
On certain vehicles, impacts directly on the cover of the airbag electronic control module (AECM) located under the driver's seat could cause the airbag to deploy inadvertently. These impacts can be caused by tossing items under the driver's seat. Correction: Airbag control module will be replaced with a current production module that incorporates revised hardware and software changes.
On certain vehicles, the driver's side front power seat may not have adequate structural strength. The seat attaching welds were not made to specification, and as a result, the seat attachment strength is compromised. Correction: The driver's side power front seat riser will be replaced with a riser that is magnesium inert gas (mig) welded.
Certain vehicles have been built with an incorrect Vehicle Emission Control Information (VECIi) label. The label incorrectly identifies the engine family and emission system bar code information, and as a result, may cause the vehicle to fail an emissions test. Correction: Correct vehicle emission control information label and installation instructions will be mailed to owners.
On certain vehicles, the transmission fluid temperature could exceed the melting point of the connector which retains the fluid line to the transmission. Should this occur, the fluid line may become disconnected from the transmission and fluid may spray onto the exhaust manifold, possibly resulting in a fire. Correction: The connector fittings on the high temperature side of the transmission fluid cooler line will be replaced with connectors incorporating a stainless steel retainer.
Showing 1-10 of 25 recalls
Check recalls for specific Dodge Ram Van model years